|
Topsurv Network Connection Using External Airlink Modem Page 1 |
|
Click on Windows Icon In Upper Left Corner |
|
Click About |
|
Check to make sure you have at least Topsurv 7.1, if not please update Before continuing with this guide. |
|
Click Configue Icon |
|
Click Survey |
|
Select Box with three dots next to GPS+ Config name |
|
Click Add button |
|
Enter in Name for configuration “Airlink Ntrip” |
|
Select Type “Network RTK” Select Corrections “VRS” Click Next |
|
Select Elevation Mask “10” Select Protocol “NTRIP” Click Next |
|
Modem Connect “Receiver” Click Next |
|
Select Radio Modem “External Modem F/W Dialup” Select the Port that you have connected the Airlink Modem to on the GPS unit. Hiper can be connected to the A or D port. The GR-3 has only one serial port which is A. Baud Rate “115200” Data “8” Parity “None” Stop “1” Click Next |
|
Select or Add IP Address and Port GeoNet Texas 12.237.204.170/2101 GeoNet Canada 12.237.204.171/2101 GeoNet Ohio 12.237.204.172.2101 Click Next |
|
Enter in the User ID and Password given to you from GeoNet. If forgotten or lost please call your local Salesman. |
|
Enter In the Dial Up Parameters Click Next. |
|
Typical Dial-Up Parameters
Att T-mobile Dialup Num: *99***1# Dialup Num: *99***1# User Id: wap@cingulargprs.com User Id: tmobile Password: CINGULAR1 Password: tmobile PIN: 0000 PIN: 0000 APN: isp.cingular APN: internet2.voicestream.com Rogers Cingular Dialup Num: 10001 or *99# Dialup Num: *99***1# User Id: User Id: ispda@cingular.com Password: Password: CINGULAR1 PIN: 0000 PIN: 0000 APN: internet.com APN: isp.cingular Sprint Verizon Dialup Num: #777 Dialup Num: #777 User Id: User Id: Password: Password: PIN: 0000 PIN: 0000 APN: APN:
|
|
Select Virual Radio Port Gr-3 = B port Hiper = A or B Port If you are using a serial cable it will be B If you are using Bluetooth it will be A Click Next |
|
Select Ant Type Enter Ant Ht Select Meas Type Click Next |
|
Enter in Survey Parameters Click Next |
|
Enter in Stakeout Parameters Click Next |
|
Enter in Stakeout Parameters Click Next |
|
Check Multipath Reduction Select Satellite System Select RTK Position “Extrapolation” Click Finish |
|
Click Ok |
|
Select Survey |
|
Select Topo |
